Brush-Holder Integrated Load Sensor Prototype for SAG Grinding Mill Motor

Miguel Carrasco; Francisco Álvarez; Velázquez, Ramiro; Javier Concha; Francisco Perez-Cotapos

doi:10.3390/electronics8111227

Brush-Holder Integrated Load Sensor Prototype for SAG Grinding Mill Motor

Journal

Electronics

ISSN

2079-9292

Date Issued

2019

Author(s)

Miguel Carrasco

Francisco Álvarez

Velázquez, Ramiro

Facultad de Ingeniería - CampAGS

Javier Concha

Francisco Perez-Cotapos

Type

text::journal::journal article

DOI

10.3390/electronics8111227

URL

https://scripta.up.edu.mx/handle/20.500.12552/4131

Abstract

One of the most widely used electro-mechanical systems in large-scale mining is the electric motor. This device is employed in practically every phase of production. For this reason, it needs to be inspected regularly to maintain maximum operability, thus avoiding unplanned stoppages. In order to identify potential faults, regular check-ups are performed to measure the internal parameters of the components, especially the brushes and brush-holders. Both components must be properly aligned and calibrated to avoid electric arcs to the internal insulation of the motor. Although there is an increasing effort to improve inspection tasks, most inspection procedures are manual, leading to unnecessary costs in inspection time, errors in data entry, and, in extreme cases, measurement errors. This research presents the design, development, and assessment of an integrated measurement prototype for measuring spring tension and other key parameters in brush-holders used in electric motors. It aims to provide the mining industry with a new, fully automatic inspection system that will facilitate maintenance and checking. Our development research was carried out specifically on the brush system of a SAG grinding mill motor. These machines commonly use SIEMENS motors; however, the instrument can be easily adapted to any motor by simply changing the physical dimensions of the prototype.